What's the best product to use for re-bluing screw heads and covering spots on firearms? All I can find are kits with multiple bottles of bluing. I just want to fix some screws that have been abused, and maybe cover a rust spot here and there. Thanks.
- 423 Views
- Last Post 19 June 2018
- Topic Is Solved
I use OxphoBlue from Brownell's.It's easy to use and gives a good finish.I used it on a Colt New Service that appears to be a suicide gun from the bluing damage and was able to blend the repaired finish in to match the original.
,,, for smaller steel parts that don't need to be hard a simple blueing technique is to just hold them in a flame until they turn a nice blue ...... don't go beyond blue ...
pre-polishing is good .... you can get a very nice blue ....the blue is not very deep but then neither is cold blue ...... if you prefer cold blue oxpho is good, and heat the parts to about 120 F. and if small enough soak them in the blue in a cup for 30 seconds . ... after either heat or cold blue be sure to oil immediately.
If you want a dull black rather than blue, Birchwood-Casey aluminum black gives a dull black finish on steel similar to Parkerizing. I find it more useful for blacking iron sights, etc.
73 de KE4SKY In Home Mix We Trust From the Home of Ed's Red in "Almost Heaven" West Virginia
Thanks. I think I'll try that oxphoblue. I wasn't aware of that product.
FWIW: use degreased 4/0 steel wool to apply oxpho. Dunno the chemistry involved, but it "bites" more and gives a darker and more even blue. Also works well when using a "rust blueing technique".
had great results from oxpho blue paste as well. For scrubbing rust and blemishes, I recommend Eez-ox and Brownells Stainless Sponge.
PS: I would NOT use steel wool. The Brownells sponge is much better imo. Does not remove the bluing like steel wool will.
The paste can be shipped without the hazmat charge, which is why I think it exists. Good stuff, just warm the part until it's almost too hot to hold (or a bit hotter) and rub over the spot repeatedly. I use 6-0 steel wool, cotton ball, or Q-tip depending on part and mood. Easier than heat-bluing for small parts, less worry about knocking too much temper out of the part, and possibly a bit more durable.
For screws and other small parts: Use hemostats or small pliers to hold the part. Heat with propane torch or over stove burner after part is dipped in 3-in-1 oil, until oil burns off. repeat to deepen color. Other oils probable will work, but I read this idea in a gunsmithing book years ago--the author said this is the only use a real gunsmith ever has for 3-in-1 oil.
- All Categories
- General Polls
- Contact Us w/ Forum Issues
- Welcome to The Cast Bullet Association Forum
- Bullet Casting
Guns & Shooting
- AR Platform
- TC Contenders & Other Single Shot Handguns
- Informal Matches & Other Shooting Events
- Gunsmithing Tips
- Gun Cleaning & Maintenance
- Benchrest Cast Bullet Shooting
- Military Bench Rest Cast Bullet Shooting
- Silhouette Shooting
- Postal Match Cast Bullet Shooting
- Factory Guns
- Black Powder Cartridge
- Hand Guns
- Lever Guns
- Single Shot Rifles
- Bolt Action Rifles
- Military Surplus Rifles
- Plinkers Hollow
- Buy, Sell or Trade
- Other Information & Reference